How I fixed STM32CubeProgrammer CUBEPROGRAMMER_ERROR_NOT_SUPPORTED
I tried to flash the DFU bootloader on the BigTreeTech Octopus V1 3D printer mainboard. However, STM32CubeProgrammer v2.8.0 showed me the following error message when trying to connect:
error_message.txt
CUBEPROGRAMMER_ERROR_NOT_SUPPORTEDI could only fix this by completely uninstalling STM32CubeProgrammer and then installing STM32CubeProgrammer v2.7.0 from the BigTreeTech Github Repo. Most likely downloading v2.7.0 from the ST homepage will also work but I didn’t verify this.
Check out similar posts by category:
3D Printing, Electronics, STM32
If this post helped you, please consider buying me a coffee or donating via PayPal to support research & publishing of new posts on TechOverflow