Wo extrudertemperaturgesteuerte Lüfter in Marlin aktivieren?
English
Deutsch
Um in Marlin einen Lüfter zu aktivieren, der automatisch basierend auf der Extrudertemperatur gesteuert wird (d.h. wenn der Extruder heiß ist, den Lüfter einschalten), Configuration_adv.h öffnen und nach dem Abschnitt Extruder cooling fans suchen und z.B. E0_AUTO_FAN_PIN auf den Pin setzen, der automatisch gesteuert werden soll.
Configuration_adv.h
/**
* Extruder cooling fans
*
* Extruder auto fans automatically turn on when their extruders'
* temperatures go above EXTRUDER_AUTO_FAN_TEMPERATURE.
*
* Your board's pins file specifies the recommended pins. Override those here
* or set to -1 to disable completely.
*
* Multiple extruders can be assigned to the same pin in which case
* the fan will turn on when any selected extruder is above the threshold.
*/
#define E0_AUTO_FAN_PIN PA_8
#define E1_AUTO_FAN_PIN -1
#define E2_AUTO_FAN_PIN -1
#define E3_AUTO_FAN_PIN -1
#define E4_AUTO_FAN_PIN -1
#define E5_AUTO_FAN_PIN -1
#define E6_AUTO_FAN_PIN -1
#define E7_AUTO_FAN_PIN -1
#define CHAMBER_AUTO_FAN_PIN -1
#define COOLER_AUTO_FAN_PIN -1
#define COOLER_FAN_PIN -1Check out similar posts by category:
3D Printing, Electronics
If this post helped you, please consider buying me a coffee or donating via PayPal to support research & publishing of new posts on TechOverflow