我如何修复 STM32CubeProgrammer CUBEPROGRAMMER_ERROR_NOT_SUPPORTED
我尝试在 BigTreeTech Octopus V1 3D 打印机主板上刷写 DFU 引导加载程序。然而，STM32CubeProgrammer v2.8.0 在尝试连接时显示以下错误消息：
error_message.txt
CUBEPROGRAMMER_ERROR_NOT_SUPPORTED我只能通过完全卸载 STM32CubeProgrammer然后从 BigTreeTech Github 仓库安装 STM32CubeProgrammer v2.7.0 来修复此问题。从 ST 主页下载 v2.7.0 很可能也可以，但我没有验证。
Check out similar posts by category:
3D Printing, Electronics, STM32
If this post helped you, please consider buying me a coffee or donating via PayPal to support research & publishing of new posts on TechOverflow