TPLink WDR3600 OpenWRT wireguard 吞吐量基准测试
TechOverflow 在运行 OpenWRT 21.02 的 TPLink WDR3600 上测试了 Wireguard 带宽/吞吐量，基于标准 iperf3 TCP 基准测试。我们在此次设置中未使用预共享密钥。
到目前为止，我们能够验证 Wireguard 带宽约为 27Mbit/s（单向），使用 iperf3 测量。
iperf3_output.txt
Connecting to host 192.168.239.254, port 5201
[ 5] local 10.9.1.104 port 57502 connected to 192.168.239.254 port 5201
[ ID] Interval Transfer Bitrate Retr Cwnd
[ 5] 0.00-1.00 sec 3.48 MBytes 29.2 Mbits/sec 0 215 KBytes
[ 5] 1.00-2.00 sec 3.86 MBytes 32.4 Mbits/sec 0 387 KBytes
[ 5] 2.00-3.00 sec 3.13 MBytes 26.2 Mbits/sec 0 470 KBytes
[ 5] 3.00-4.00 sec 3.37 MBytes 28.3 Mbits/sec 0 470 KBytes
[ 5] 4.00-5.00 sec 3.31 MBytes 27.8 Mbits/sec 0 470 KBytes
[ 5] 5.00-6.00 sec 3.31 MBytes 27.8 Mbits/sec 0 470 KBytes
[ 5] 6.00-7.00 sec 3.31 MBytes 27.8 Mbits/sec 0 470 KBytes
[ 5] 7.00-8.00 sec 2.76 MBytes 23.1 Mbits/sec 0 470 KBytes
[ 5] 8.00-9.00 sec 3.31 MBytes 27.8 Mbits/sec 0 470 KBytes
[ 5] 9.00-10.00 sec 2.76 MBytes 23.1 Mbits/sec 0 470 KBytes
- - - - - - - - - - - - - - - - - - - - - - - - -
[ ID] Interval Transfer Bitrate Retr
[ 5] 0.00-10.00 sec 32.6 MBytes 27.4 Mbits/sec 0 sender
[ 5] 0.00-10.14 sec 32.0 MBytes 26.4 Mbits/sec receiver测试期间，top 始终显示 0% 空闲 CPU 负载，负载约为 51% sys 和 49% sirq。
使用的命令是
iperf3_server.sh
iperf3 -s在 WDR3600 上和
iperf3_client.sh
iperf -c [IP address of WDR3600]在客户端上。
Check out similar posts by category:
Networking, Wireguard
If this post helped you, please consider buying me a coffee or donating via PayPal to support research & publishing of new posts on TechOverflow